7 0 7 0 - 2 0 MICROSCIENCE NO MORE PRODUCED Native| Translation ------+-----+-----+----- Form 3.5"/HH Cylinders 960| | | Capacity form/unform 94/ MB Heads 5| | | Seek time / track 18.0/ ms Sector/track 40| | | Controller IDE / AT Precompensation 960 Cache/Buffer KB Landing Zone 960 Data transfer rate 1.000 MB/S int Bytes/Sector 512 MB/S ext Recording method RLL 2/7 operating | non-operating -------------+-------------- Supply voltage 5/12 V Temperature *C | Power: sleep W Humidity % | standby W Altitude km | idle W Shock g | seek W Rotation RPM 3600 read/write W Acoustic dBA spin-up W ECC Bit MTBF h 36000 Warranty Month Lift/Lock/Park YES Certificates ********************************************************************** L A Y O U T ********************************************************************** MICROSC. 7070-20/7100-00/-20/-21/7200-00 PRODUCT DESCRIPTION +---------------------------------------------------------+ | +----+J4|XX | 1----8 |XX Power | |1 | | | |1 | |XX I | |XX N | |XX T | |XX E | |XX R | |XX F | |XX A | |XX C | |XX E | |XX +---------------------------------------------------------+ ********************************************************************** J U M P E R S ********************************************************************** MICROSC. 7070-20/7100-00/20/21/7200-00 PRODUCT DESCRIPTION Jumper Setting ============== J4 Master/Slave Select ---------------------- Pins 1-2 OPEN Single drive only Pins 7-8 OPEN Pins 1-2 CLOSED Master drive in a two drive system Pins 7-8 OPEN Pins 1-2 OPEN Slave drive in a two drive system Pins 7-8 CLOSED The other pins are not used! ********************************************************************** I N S T A L L ********************************************************************** MICROSC. 7XXX/8XXX SERIES JUMPER SETTINGS 280095-004, REV. A Installation Procedure ---------------------- 1. Installation precautions --------------------------- Four (4) 6-32UNC screws, with 3/16" (4.78mm) maximum screw length, are required for installation. Use caution when installing the mounting screws to ensure no contact is made with drive's printed circuit board. 2. In the CMOS (System BIOS) setup, select drive type as follows ---------------------------------------------------------------- Select a hard drive type that is equal to or less than the formatted capacity of the drive. NOTE Drive parameters cannot exceed the specified capacity. - Use user defined type or manually enter the drive parameters. 3. Disk partion options ----------------------- Use DOS "FDISK" to create the partition table. Utility software such as Disk Manager or Speedstor may be used. 4. High Level Format Options ---------------------------- If DOS "FDISK" is used to create the partitions, then use DOS "FORMAT" to do the high level format. If Disk Manager is used to create the partitions, then use Disk Manager to do the high level format. If Speedstor is used to create partitions, then use Speedstor to do the high level format. Always low-level formatted at the factory!