D 2 3 7 7 W D D NEC NO MORE PRODUCED Native| Translation ------+-----+-----+----- Form 9"/FH Cylinders 1024| | | Capacity form/unform / 1415 MB Heads 27| | | Seek time / track 15.0/ 5.0 ms Sector/track | | | Controller IPI-2 Precompensation Cache/Buffer KB Landing Zone Data transfer rate MB/S int Bytes/Sector 512 3.000 MB/S ext Recording method operating | non-operating -------------+-------------- Supply voltage Temperature *C 10 40 | -10 50 Power: sleep W Humidity % 20 80 | 8 90 standby W Altitude km 3.000| 12.000 idle W Shock g | seek W Rotation RPM 3600 read/write W Acoustic dBA spin-up W ECC Bit MTBF h 20000 Warranty Month Lift/Lock/Park YES Certificates ********************************************************************** J U M P E R S ********************************************************************** NEC D2377 WDD JUMPER SETTING Jumper Setting -------------- | | Ready O| Fault O| Seek Error O| I/O Error O| Protected O| | CE RESET/ +-+SW1 INTERRUPT Switch +-+ | Open Closed FUNTION NAME | OPEN | CLOSED +----+SW2 Write Protect |Write Permit |Write Permit =>|x |8 Disable Port-B |Enable Port-B |Disable Port-B =>|x |7 Disable Port-A |Enable Port-A |Disable Port-A =>|x |6 Test Seek 2 |Test Seek Disable |Test Seek Enable =>|x |5 Test Seek 1 |Test Seek Disable |Test Seek Enable =>|x |4 Test Mode Select |Test Mode Disable |Test Mode Enable =>|x |3 Diagnostic Mode 2 |Normal Mode |Diagnostic Mode =>|x |2 Diagnostic Mode 1 |Normal Mode |Diagnostic Mode =>|x |1 | | +----+ | | +----+SW3 Start Delay Control|Delay Permit |Delay Inhibit =>| x|8 Unit Address 2(2) |"True" |"False" =>| x|7 Unit Address 2(1) |"True" |"False" =>| x|6 Unit Address 2(0) |"True" |"False" =>| x|5 Motor Start Mode |Remote Mode |Local Mode =>| x|4 Sweep Trigger Mode |Override Sweep Mode|Self Trigger Mode=>| x|3 Sweep Cycle Control|Enable |Disable =>| x|2 RESERVED | | =>| x|1 +----+ +----+SW4 +| x|8 || x|7 || x|6 RESERVED ---------------------+| x|5 || x|4 || x|3 || x|2 +| x|1 +----+ | | |