HEWLETT-PACKARD COMPANY

D2384-63031

Data bus:

16-bit ISA

Size:

Half-length, full-height card

Hard drive supported:

Two IDE(AT) drives

Floppy drives supported:

Two 360KB, 720KB, 1.2MB, or 1.44MB drives

CONNECTIONS

Function

Location

9-pin serial port 1 - external

CN1

25-pin parallel port - external

CN2

40-pin IDE(AT) connector

CN3

34-pin cable connector - floppy drive

CN4

USER CONFIGURABLE SETTINGS

Function

Location

Setting

»

Parallel port is LPT1

SW1/3

Closed

 

Parallel port is LPT2

SW1/3

Open

»

IDE(AT) primary address is 1F0h

SW1/4

Closed

 

IDE(AT) secondary address is 170h

SW1/4

Open

»

Floppy disk primary address is 3F0h

SW1/5

Closed

 

Floppy disk secondary address is 370h

SW1/5

Open

»

Serial Port enabled

SW1/6

Closed

 

Serial Port disabled

SW1/6

Open

»

Parallel port enabled

SW1/7

Closed

 

Parallel port disabled

SW1/7

Open

Note: Secondary Addresses for both floppy and IDE(AT) not supported.

USER CONFIGURABLE SETTINGS (CONTINUED)

Function

Location

Setting

»

IDE(AT) interface enabled

SW1/8

Closed

 

IDE(AT) interface disabled

SW1/8

Open

»

Floppy drive interface enabled

SW1/9

Closed

 

Floppy drive interface disabled

SW1/9

Open

»

Factory configured - do not alter

SW1/10

N/A

SERIAL PORT ADDRESS SELECTION

COM

SW1/1

SW1/2

»

COM1

Closed

Closed

 

COM2

Open

Closed

 

COM3

Closed

Open

 

COM4

Open

Open

SERIAL PORT INTERRUPT SELECTION

IRQ

J2/1

J2/2

J2/3

J2/4

»

IRQ4(COM1)

Closed

Open

Open

Open

 

IRQ3(COM2)

Open

Closed

Open

Open

 

IRQ10(COM3)

Open

Open

Closed

Open

 

IRQ11(COM4)

Open

Open

Open

Closed

Note: IRQ settings should correspond to switch settings 1 & 2.

PARALLEL PORT IRQ SELECTION

IRQ/LPT

J1/pins 1 & 2

J1/pins 3 & 4

»

IRQ7(LPT1)

Closed

Open

 

IRQ5(LPT2)

Open

Closed

Note: IRQ settings should correspond to switch setting 3.

MISCELLANEOUS TECHNICAL NOTES

The location of SW1/1 and its open & closed positions are not identified.