Data bus:	16-bit, ISA
Size:	Half-lenght, full-height card
Hard drive supported:	Two IDE (AT) Interface drives
Floppy drives supported:	Two 360KB, 720KB, 1.2MB, or 1.44MB drives
Maximum heads/cyl.:	8 heads and 1024 cylinders

CONNECTIONS
Function	Location
34-pin control cable connector-hard drive	CN1
40-pin IDE (AT) Interface control cable connector-internal	CN2
4-pin connector-drive active LED	CN3

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	Factory configured - do not alter	JP1	pins 2 & 3 closed
»	Factory configured - do not alter	JP2	pins 1 & 2 closed
»	Supports systems greater than 12mhz	JP3	pins 1 & 2 closed
	Supports 12mhz systems	JP3	pins 2 & 3 closed
»	Hard drive port address is 1F0-1F7h & 3F6-3F7h	JP4	pins 1 & 2 closed
	Hard drive port address is 170-177h & 3760-377h	JP4	pins 2 & 3 closed
	Not used	S1/1-7	closed
»	Floppy drive enabled	S1/jumper 8	closed
	Floppy drive disabled	S1/jumper 8	open
»	Hard drive enabled	S1/jumper 9	closed
	Hard drive disabled	S1/jumper 9	open
»	Factory configured - do not alter	S1/jumper 10	all