M P C - 3 0 8 4 A T P I C O B I R D FUJITSU Native| Translation ------+-----+-----+----- Form 3.5"/SLIMLINE Cylinders 11116|16383| | Capacity form/unform 8450/ MB Heads 6| 16| | Seek time / track 10.5/ 2.0 ms Sector/track | 63| | Controller ULTRA ATA Precompensation Cache/Buffer 256 KB Landing Zone Data transfer rate 14.000 MB/S int Bytes/Sector 512 33.300 MB/S ext UDMA Recording method EPRML16/17 operating | non-operating -------------+-------------- Supply voltage 5/12 V Temperature *C 5 55 | -40 60 Power: sleep W Humidity % 8 80 | 5 85 standby W Altitude km -0.060 3.000| -0.060 12.000 idle 4.2 W Shock g 10 | 75 seek W Rotation RPM 5400 read/write 5.5 W Acoustic dBA spin-up W ECC Bit SMART MTBF h 500000 Warranty Month Lift/Lock/Park YES Certificates ********************************************************************** L A Y O U T ********************************************************************** FUJITSU MPC-3032AT/3043/3064/3084/3096AT JUMPER SETTINGS A1CA01675-0 +---------------------------------------------------------+ | |XX | |XXI | |XXN | |XXT | |XXE | |XXR | |XXF | |XXA | |XXC | |XXE | |XX | |+-+Master | || |/Slave | |+-+ | |XX Power | |XX +---------------------------------------------------------+ ********************************************************************** J U M P E R S ********************************************************************** FUJITSU MPC-3032/3043/3064/3084/3096AT JUMPER SETTING A1CA01675-0030 Jumper Settings =============== Master Drive ------------ +--2-4-6+ | X * *| | X xxx| +--1-3-5+ Slave Drive ----------- +--2-4-6+ |xxx * *| | * xxx| +--1-3-5+ Cable Select Mode Setting (CSEL) -------------------------------- Cable select mode gives an alternative method by which the drive may be set to Master or Slave. A special cable is needed to implement this features and should only be used if supported by BOTH drives. +--2-4-6+ | xxx *| | * xxx| +--1-3-5+ ******************************************************************** Spare Jumper Settings --------------------- If the drive cannot be recognized by the system, due to non- translating BIOS (legacy), which does not allow drives with capacities greater than 2.1GB, the following jumper setting should be applied. Master Drive Setting -------------------- +--2-4-6+ | X * X| | X * X| +--1-3-5+ Slave Drive Setting ------------------- +--2-4-6+ |xxx * X| | * * X| +--1-3-5+ Cable Select Mode Setting (CSEL) -------------------------------- +--2-4-6+ | xxx X| | * * X| +--1-3-5+ ********************************************************************** I N S T A L L ********************************************************************** FUJITSU MPC AT JUMPER SETTINGS A1CA01675-0030-01 Notes on installation ===================== Installation direction ---------------------- horizontally vertically +-----------------+ +--+ +--+ | | | +-----+ +-----+ | | | | | | | | | +-+-----------------+-+ | | | | | | +---------------------+ | | | | | | | | | | | | x x | | | | | | +------x------x-------+ | +-----+ +-----+ | +-+------x--x-------+-+ +--+ +--+ | xx | | x x | +---x--------x----+ x x