ADVANCED INTERLINK CORPORATION

AICETHER-16/10BT

NIC Type

Ethernet

Transfer Rate

10Mbps

Data Bus

16-bit ISA

Topology

Star

Wiring Type

Unshielded twisted pair

Boot ROM

Available

INTERRUPT REQUEST

IRQ

JP2A

JP2B

JP2C

JP2D

JP2E

JP2F

JP2G

 

2/9

Open

Open

Open

Open

Open

Closed

Open

»

3

Open

Open

Open

Open

Closed

Open

Open

 

5

Open

Open

Open

Closed

Open

Open

Open

 

10

Open

Open

Open

Open

Open

Open

Closed

 

11

Closed

Open

Open

Open

Open

Open

Open

 

12

Open

Closed

Open

Open

Open

Open

Open

 

15

Open

Open

Closed

Open

Open

Open

Open

I/O BASE ADDRESS

Address

JP2I

JP2J

 

200h

Closed

Closed

 

210h

Open

Closed

»

300h

Closed

Open

 

310h

Open

Open

BOOT ROM ADDRESS

Address

JP3A

JP3B

C8000h

Closed

Closed

CC000h

Closed

Open

D8000h

Open

Closed

DC000h

Open

Open

BOOT ROM

Setting

JP3C

»

Disabled

Open

 

Enabled

Closed

Note:Location of the boot ROM may vary on different revisions of this card.

SEGMENT LENGTH

Maximum Segment Length

JP5

100 meters

Closed

300 meters

Open

Note:Segment length is the distance from the card to the hub.

COMPATIBILITY MODE

Setting

JP10

»

Disabled

Open

 

Enabled

Closed

Note:Compatibility mode is provided to compensate for timing differences between the card and host computer.

TX/RX CROSSOVER

Mode

SW1

»

Normal

On

 

Crossover

Off

Note:If the diagnostic LEDs indicate that the transmit & receive wires are reversed (LED1 Off, Hub LED Off) you can correct the problem by using the crossover option.

FACTORY CONFIGURED SETTINGS

Jumper

Setting

JP2H

Open

DIAGNOSTIC LED(S)

LED1

Hub LED

Condition

On

On

Network connection is good

Off

Off

Transmit/Receive wires reversed at card

On

Off

Receive polarity reversed at hub

Off

On

Receive polarity reversed at card

Note:The Hub LED is located on the hub, not on the card.